Float Switches

ST70 ABbasic float switchOperation viatwo displacement weights.Can be used for filling and emptying.Bottom or side mounting110v 10 Amp Max or 230v 5 Amp Max Inductive Loads, can be used for pump control.A basic float switch to control a pump for tank filling or tank emptying. Levels can be achieved by positioning the two weights to give a differential of 50mm to 1000mm.110v 10 Amp Max or 230v 7.5 Amp Max Inductive loads, can be used for pump control. If pump inductive load is higher then a contactor/starter/control panelmust be used. Same applies for applications for three phase pumps.

Submatic electronic control units to be used with two 'N's allowing emptying or filling without the need for float switches. levels are dependant on the difference in the positions of the probes.

Submatic electronic control units to be used with two 'N's allowing emptying or filling without the need for float switches. levels are dependant on the difference in the positions of the probes.

Waterguard & Vole 230V (NETT).Low lever control unit complete with probe set. Please see PDF attachment.