12v & 24v Pumps

Sotera’s SS400 Chemtraveller short-frame series electric Santoprene® diaphragm pump is designed for the chemical transfer of agricultural pesticides, herbicides, fertilizers, mild acids, soaps, and water.The Sotera SS435B is a 12V DC non-explosion-proof chemical transfer pump that is capable of producing up to 13GPM at 15PSI (1 Bar) maximum pressure. The pump utilizes a glass-reinforced polypropylene housing that is designed with Santoprene® diaphragms, EPDM elastomers, Chemtraveller - Short Frame with 825 digital meter. The SS435B is designed to transfer agricultural chemicals, mild acids, soaps and water. Please always refer to the Sotera Chemical Resistance Guide for compatibility. This pump includes 1" accessories such as suction and discharge hose, ball valve nozzle with anti-drip tip, female camlock coupler, along with various fittings and clamps.Flow rates up to 13GPMMaximum outlet pressure 15 PSI (1 Bar)8" Hg 'Dry Lift' [9 ft (2.7M) of water]Maximum particle size up to 0.100" diameterPump can run dry without damageThermally protected motor

Mascontrol isa electronic pressure switch and protection device. They can be fitted to almost any pump with an outlet pressure of two bar minimum to ten bar maximum with a flow rate of between 40-200 litres per minute.The mascontrol will turn off in the case of no water to protect the pump from dry running. Suitable for most water systems from well, tank or low pressure mains.A solenoid must be installed if the pump being used has a high wattage/current rating.Mascontrol12 Volt0.18Kw Maximum20 Amp Maximum1" Male BSP Inlet/Outlet1.4Kg

This a low voltage gear pump with built in bypass valve.Electric Gear pump for the delivering non-aggressive viscuos liquids which do not exceed a viscosity between 1° to 7°.Suitable especially for delivering water, wine, olive oil, milk, diesel and synthetic or mineral oils.Designed for oils it will pump 1450 l/h or 24 l/m max flow to 30metre.Supplied with On / Off switch and handle with lead and clips

Mascontrol is a electronic pressure switch and protection device. They can be fitted to almost any pump with an outlet pressure of two bar minimum to ten bar maximum with a flow rate of between 40-200 litres per minute.The mascontrol will turn off in the case of no water to protect the pump from dry running. Suitable for most water systems from well, tank or low pressure mains.A solenoid must be installed if the pump being used has a high wattage/current rating.Mascontrol24 Volt0.37Kw Maximum20 Amp Maximum1" Male BSP Inlet/Outlet1.4KgH 165mm x W 210mm x L 250mm

NASTEC 4HS VSD BOREHOLE PUMPSThe NASTEC4HSseries is a range of 4” electric submersible pumps for borehole & well applications.Construction characteristics and use of specific materials allow 4HS to be suitable for drinking water applications.Features include;Built-in integrated inverter controlled by CM control module.Multistage pump made of AISI 304 stainless steel.Three-phase water-filled permanent magnet synchronous motor with encapsulated resin stator, fully constructed of AISI 304 stainless steel.The Pump Integrated Inverter provides the following features;Automatic variable pump speed to maintain set-pressure regardless of water demand. Thus the pump only operates at a speed that matches demand, significantly reducing power consumption and extending pump life.Starts and stops pump gently, thus reducing in-rush currents/power consumption & mechanical stresses.Protects pump and drive from abnormal conditions such as overload, surges, under/over-voltage, dry running, and any abnormal conditions.Integrated onboard inverter eliminates the requirement for expensive electrical filters and shielded cables and reduces electromagnetic emissions to absolute minimums.The 4HS product range matches applications in residential & commercial markets for water supply, water pressurization and irrigation.Compared to conventional solutions 4HS offers:Energy-saving operation.Quick and simplified application.System reliability..The 4HS range submersible pumps are designed to provide customers a ready to-use product. Packages include;4HS pump including 2,5 m / 8 ft flat cable lead (ACS-WRAS-KTM compliant)Surface control module (CM)Cable junction kitPressure transducer 0-16 bar / 0-250 psiOperating Manual

Non-modulating float valves fully when the liquid level in a tank reaches a pre-set low point. The opening operation allows for the tank to be refilled to a pre-set high point, at which time the valve closes drip-tight.Modulating float valves maintain a constant liquid level in a storage tank by compensating for variations in supply or demand and are used to control the flow into or out of a tank by either opening or closing on a rising level.Cla-Val Altitude Control Valves regulates the high water level in reservoirs without the need for floats or other devices. These non-throttling valves remain fully open until the pre-set shut-off point is reached. Altitude valves can be configured for one-way or two-way flow depending on system requirements and can be furnished with auxiliary controls for multiple functions such as pressure sustaining, pressure reduction, rate-of-flow control, solenoid override or other parameters as needed.

Battery powered self priming pump for fuel oil transfer.Complete with trigger gun,suction 2m and delivery4m hoses, filter & hosetails and clips 3/4" inlet and outlet. 40 litres per min max flow and 4m suction lift.12v 16 amp motor supplied with lead and battery clipsVane pump for positive priming with by pass